How do I stop the command line displaying a browser after conversion?

	JafSoft Support Forums
	Products: AscToHTM (text to HTML) / AscToPDF (text to PDF) / AscToRTF (text to RTF) / Detagger (HTML to text and markup removal)
	Forum options: Forum Index Register Login Search FAQ Log Out	Member options: My Profile Inbox Member List Address Book My Subscription My Forums
	Note: Some forums require a login other than "Guest" in order to post messages and replies

How do I stop the command line displaying a browser after conversion?

Logged in as: Guest

Users viewing this topic: none

Printable Version

All Forums > [Hints and Tips] > Frequently Asked Questions > How do I stop the command line displaying a browser after conversion?

Page: [1]

Message

<< Older Topic Newer Topic >

How do I stop the command line displaying a browser aft... - 5/17/2006 2:43:45 PM

Jaf

Posts: 80
Joined: 2/1/2006
Status: offline

quote:

How do I prevent the browser from showing the results after each conversion when I use the command line conversion?

In the interface, I see that you can deselect the View Results...but I can't find out how to do it when I run it from the command line.

It's not obvious, but when running the Windows version from the command line you can configure this via the

Settings -> drag'n'drop properties

menu tab. This was primarily intended to configure the behaviour when you drop a file onto an icon of the Windows version, but the same options are in fact used by Windows version when invoked from the command line.

However, if you're running the Windows version from the command line, you should perhaps consider running the console version instead. This supports the same command line options, and should yield identical results, but it won't be tempted to start the Windows version, display a status window or launch the results file in a browser after conversion. It will probably consume a few resources as well.

For these reasons the console version is usually recommended for command line operation.